Weather

Vantage Pro2 Plus Upgrade Kit. Save over $100 when compared to buying each component separately. Upgrade a vantage Pro2 to a Vantage Pro2 Plus with...

Add these high gain external antenna to your Gateway and/or Nodes to increase the transmission distance of an EnviroMonitor mesh network up to 6,00...

A motor-driven fan draws a constant airflow through the sensor chamber at 500 feet per minute (2,5 m/s). At night, when the effects of radiation a...

Includes waterproof coupler kits (not shown in photograph) for joining two cables together, indoors or out. Not suitable to extend any Temperature...

Easily replace the tipping bucket assembly in your rain collector with the more accurate tipping spoon. Reports in inches. Comes with a 40′ (12 m) ...

Replacement reed switch cover for rain collector tipping bucket in all wireless and cabled Vantage Pro2, original Vantage Pro, Weather Wizard II, a...

Includes waterproof coupler kits (not shown in photograph) for joining two cables together, indoors and out. Not suitable to extend any Temperatur...

Replacement kickstand for Vantage Pro2 and original Vantage Pro consoles. Does not include Hinge Arm or back cover. For full assemply, see the Re...

For mounting a solar radiation sensor, a UV sensor, or a radiation shield. Bracket is pre-driller for easy mounting. Includes mounting hardware.

Replacement magnet end cap for tipping bucket for rain collector cones in all wireless and cabled Vantage Pro2 and original Vantage Pro stations ma...

PCBA for Vantage Vue Wireless Sensor Suite Weather Station, US

Replacement reed switch for rain collector tipping spoon in all wireless and cabled Vantage Pro2 sensor suites. 19” (0,5 m) sensor cable.

This replacement wind vane for Vantage Pro2 stations includes a brass tip and is compatible with anemometers that have D-shaped vane shafts. To avo...

Use with Long-Range Repeater to extend range up to 1,580′ (475 m) in all directions. Each repeater requires two antennas. You can combine omni and...

A temperature probe placed in the direct sun, or where it is exposed to a radiant heat source such as a building or concrete will not provide accu...

8' (2.5M) extension cable for serial port versions of WeatherLink for Vantage stations.

Replacement base for rain collector cones in all wireless and cabled Vantage Pro2 stations. Does not include tipping bucket assembly.

Install your Weather Envoy or Envoy8X outside with solar power and shelter. Use with a Universal Shelter to power a Vantage Vue or Vantage Pro2 co...

Replacement battery door for all Vantage Pro2 and Vantage Pro consoles.

Our USB-to-Serial cable will connect a device with a serial connector to your USB port on your computer. For use with WeatherLink Software with se...

Use to adapt standard (inches) rain collector tipping bucket to metric measurements (mm) in all wireless and cabled Vantage Pro2 and Vantage Pro st...

The Vantage Pro2 GroWeather wireless weather station is an agriculture-focused weather station that includes all the features of Vantage Pro2, plus...

Install your Vantage Vue or wireless Vantage Pro2 console or Weather Envoy outside with solar power and shelter. (For cabled Vantage Pro2 console ...

Charges an EnviroMonitor Node where sunlight is too low to use solar. Includes 5.5 ft. (1,6 m) cable.